Jewelry Sizing Guide

For Rings: 

For Chain Bracelets:

Most of our chain bracelets are already adjustable, for other bracelets such as tennis bracelets, please bring a piece of thread or a thin chain and wrap it around your wrist, slip one finger under the thread to make It a little loose. Measure the length of the thread or chain against a ruler, determine your size in CM and select the appropriate length from the drop down menu. If you are unsure about your size, or cannot find your size - please contact us, we're more than happy to help!

For Cuff Bracelets and Bangles: 

If the cuff you are purchasing opens with a hinge mechanism, then please use the same sizing instructions as for a tennis/chain bracelet. If however the cuff does not open with a hinge, please use the sizing instructions below for a closed bangle bracelet. 

1. Hold your hand as if you were putting on a bangle. Bring all of your fingers together with your thumb and little finger touching.
2. Measure around the hand at the widest point with a tape measure or a strip of paper/thread. Be sure to pull the paper or tape measure snug against your skin. Mark the paper with a pen and measure it with a ruler. This measurement is the circumference of your hand.
3. Use the following chart to determine the diameter of your hand, based on the circumference. After determining the diameter, choose a bangle that’s at least 1/4 inch (0.7cm)  larger in diameter than the diameter measurement of your hand,

For Chain Necklaces/Chokers and Collar Necklaces: 

Most of our chain necklaces and chokers are already adjustable, for other necklaces such as tennis necklaces, please bring a piece of thread or a thin chain and wrap it around your neck (adjust it so that the thread sits at the length you would like (choker, collar or lower), take note of the length of thread used then measure the thread against a ruler, determine your size in CM and select the appropriate length from the drop down menu. If you are unsure about your size, or cannot find your size - please contact us, we're more than happy to help!

Please note that our solid Gold collar necklaces open and close with a hinge mechanism in the back, when taking your measurements using a thread please make it so that it ends just slightly above your clavicles at the midpoint in the front of the neck. If the specific design requires it to be lower, keep that in mind when measuring. Please ask us if you need any assistance in selecting your appropriate size. 

For Chain Anklets:

All of our anklets are adjustable to fit most sizes, if you need a larger size please do not hesitate to contact us.  

Thank You!